This Coleman cooler replacement power cord is the same original factory equipment that was originally installed on and included with Coleman coolers. It consists of two power wire cords. The shorter cord is wired directly into the cooler. The longer cord plugs into the vehicles lighter socket, the other end plugs into the short wire which is attached to the cooler.
This Replacement Power Cord works with these Coleman thermoelectric coolers 5615/5640/5641/5642/5644
Replacing the power cord on your Coleman cooler:
- Remove panel to access power cord. On the 16 quart (5615), four screws are located under the lid seal.
- Write down the location of all wires before starting. Disconnect power cord wires from the terminal block.
- Install the new power cord.
- Replaces all wires using the wiring diagram in the cooler. The wire diagram should be labeled "Instructions for Use".
Need a replacement fan motor too? While Coleman continues to manufacture this replacement power cord, they no longer produce a replacement fan motor. 12Volt-Travel.com has the solution. This
RoadPro Replacement Fan Motor works with the same Coleman coolers as this power cord.
